Network Working Group
Request for Comments: 3737
Category: Standards Track
B. Wijnen
Lucent Technologies
A. Bierman
Cisco Systems, Inc.
April 2004

IANA Guidelines for the Registry of

Remote Monitoring (RMON) MIB modules

Status of this Memo

This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited.

Copyright Notice

Copyright © The Internet Society (2004). All Rights Reserved.

Abstract

This document defines the procedures for IANA to administer and maintain the Object Identifier (OID) tree under the Remote Monitoring (rmon) root. This memo also documents the currently assigned values.

1. Introduction

The RMONMIB Working Group so far has maintained its own registry for OID assignments for new MIB modules under the root OID for rmon [RFC2819]. This has worked reasonably well, although errors had to be corrected at a late stage one or two times, and a few now defunct assignments have been made as well.

It is also a somewhat non-standard way of doing things, because normally a new standards track MIB module will get a MIB root assigned at the time that the module is being published as part of an RFC.

This document lists the currently assigned rmon OIDs. It also describes the procedures and rules for new assignments and asks IANA to take over the responsibility for existing and future assignments.

The current assignments are not all too logical. Initially normal MIB OIDs were assigned under rmon, but at a later time the WG used the rmon root OID to create new MIB modules underneath it. Some people will claim 'an OID is just an OID', and while this is true, it does not make things easier if the organisation of OIDs is not logical. However, we cannot change what has been assigned in the past. From now on, only MODULE-IDENTITY macro (MIB root) assignments will be made (by IANA) under the 'rmon' node. Within a MIB module, the working group authors/editors can then assign their own OIDs according to normal procedures.

2. Currently assigned OIDs under the rmon root

At the time of this writing, the following OIDs have been assigned and IANA has picked up this information in their public registry of assigned values. They are listed as part of the already existing smi-numbers registry at:

       http://www.iana.org/assignments/smi-numbers
       
       ...mib-2.rmon (1.3.6.1.2.1.16)

The assignments under ...mib-2.rmon were maintained by the RMONMIB Working Group until publication of RFC 3737. Some (early) assignments may not look all too logical. That is true, but that is history and cannot be changed. From now on, only MODULE-IDENTITY macro (MIB root) assignments will be made (by IANA) under the 'rmon' node.

   Key: nnn == { rmon nnn }
   
      nnn   descriptor            OID Type                 Document
   
        0   rmonEventsV2          Notifications root       [RFC2819]
        1   statistics            OID                      [RFC2819]
        2   history               OID                      [RFC2819]
        3   alarm                 OID                      [RFC2819]
        4   hosts                 OID                      [RFC2819]
        5   hostTopN              OID                      [RFC2819]
        6   matrix                OID                      [RFC2819]
        7   filter                OID                      [RFC2819]
        8   capture               OID                      [RFC2819]
        9   event                 OID                      [RFC2819]
       10   tokenRing             OID                      [RFC1513]
       11   protocolDir           OID                      [RFC2021]
       12   protocolDist          OID                      [RFC2021]
       13   addressMap            OID                      [RFC2021]
       14   nlHost                OID                      [RFC2021]
       15   nlMatrix              OID                      [RFC2021]
       16   alHost                OID                      [RFC2021]
       17   alMatrix              OID                      [RFC2021]
       18   usrHistory            OID                      [RFC2021]
       19   probeConfig           OID                      [RFC2021]
       20   rmonConformance       OID                      [RFC2021]
       21   mediaIndependentStats OID                      [RFC3273]
       22   switchRMON            M-I                      [RFC2613]
       23   apm                   M-I                      [RFC3729]
       24   available
       25   pmCapsMIB             M-I (defunct)
       26   dsmonMIB              M-I                      [RFC3287]
       27   interfaceTopNMIB      M-I                      [RFC3144]
       28   reserved for sspmMIB  M-I    [..rmonmib-sspm-mib-nn.txt]
       29   hcAlarmMIB            M-I                      [RFC3434]
       30   reserved for tpmMIB   M-I     [..rmonmib-tpm-mib-nn.txt]
       31   reserved for raqmon   M-I  [..rmonmib-raqmon-mib-nn.txt]
       32   reserved for raqmonDs M-I  [..rmonmib-raqmon-pdu-nn.txt]
   
    Key: xxx == { rmon.rmonConformance xxx }
   
       ...mib-2.rmon.conformance (1.3.6.1.2.1.16.20)
   
      xxx   descriptor            OID Type                 Document
   
        1   rmon2MIBCompliances   OID                      [RFC2021]
        2   rmon2MIBGroups        OID                      [RFC2021]
        3   smonMIBCompliances    OID                      [RFC2613]
        4   smonMIBGroups         OID                      [RFC2613]
        5   hcRMON                M-I                      [RFC3273]
        6   hcRmonMIBCompliances  OID                      [RFC3273]
        7   hcRmonMIBGroups       OID                      [RFC3273]
        8   rmonMibModule         M-I                      [RFC2819]
        9   rmonCompliances       OID                      [RFC2819]
       10   rmonGroups            OID                      [RFC2819]

3. How to request a new assignment for a MIB module

When anyone is writing a internet-draft for which a new assignment is needed/wanted under the rmon OID, then the proper way to do so is as follows:

EXAMPLE-MIB DEFINITIONS ::= BEGIN

IMPORTS

        rmon          FROM RMON-MIB

.. other imports ..

      exampleMIB  MODULE-IDENTITY

... other normal MODULE-IDENTITY stuff ...

      ::= { rmon nnn }  -- IANA: please assign nnn
                        -- RFC-Editor: replace nnn with IANA-assigned
                        --             number and remove this note

IANA will assign the number as part of the RFC publication process.

4. Security Considerations

This memo describes procedures for IANA assignment of OBJECT IDENTIFIER values, and has no impact on the security of the Internet.

5. IANA Considerations

IANA has picked up the initial set of assignments and integrated them into the existing registry for smi-numbers at:

      http://www.iana.org/assignments/smi-numbers

The list is presented in Section 2.

IANA is requested to maintain this registry for future assignments. New assignments can only be made via Standards Action as described in [RFC2434].

IANA will assign the number as part of the RFC publication process.

6. Acknowledgments

This document was produced as a result of discussion between the Operations and Management AD responsible for Network Management and the WG chair for the RMONMIB Working Group. Thanks to Andy Bierman for keeping and administering the registry up to this point in time.

The document has been reviewed by the RMONMIB Working Group.

7. Normative References

   [RFC1513]  Waldbusser, S., "Token Ring Extensions to the Remote
   
              Network Monitoring MIB", RFC 1513, September 1993.
   
   [RFC2021]  Waldbusser, S., "Remote Network Monitoring Management
              Information Base Version 2 using SMIv2", RFC 2021, January
              1997.
   
   [RFC2434]  Narten, T. and H. Alvestrand, "Guidelines for Writing an
              IANA Considerations Section in RFCs", BCP 26, RFC 2434,
              October 1998.
   
   [RFC2613]  Waterman, R., Lahaye, B., Romascanu, D. and S. Waldbusser,
              "Remote Network Monitoring MIB Extensions for Switched
              Networks Version 1.0", RFC 2613, June 1999.
   
   [RFC2819]  Waldbusser, S., "Remote Network Monitoring Management
              Information Base", STD 59, RFC 2819, May 2000.
   
   [RFC3144]  Romascanu, D., "Remote Monitoring MIB Extensions for
              Interface Parameters Monitoring", RFC 3144, August 2001.
   
   [RFC3273]  Waldbusser, S., "Remote Network Monitoring Management
              Information Base for High Capacity Networks", RFC 3273,
              July 2002.
   
   [RFC3287]  Bierman, A., "Remote Monitoring MIB Extensions for
              Differentiated Services", RFC 3287, July 2002.
   
   [RFC3434]  Bierman, A. and K. McCloghrie, "Remote Monitoring MIB
              Extensions for High Capacity Alarms", RFC 3434, December
              2002.
   
   [RFC3729]   Waldbusser, S., "Application Performance Measurement
              MIB", RFC 3729, March 2004.

8. Authors' Addresses

Bert Wijnen
Lucent Technologies
Schagen 33
3461 GL Linschoten
Netherlands

   Phone: +31-348-407-775
   EMail: [email protected]

Andy Bierman
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA
USA

   Phone: +1-408-527-3711
   EMail: [email protected]

9. Full Copyright Statement

Copyright © The Internet Society (2004). This document is subject to the rights, licenses and restrictions contained in BCP 78 and except as set forth therein, the authors retain all their rights.

This document and the information contained herein are provided on an "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

Intellectual Property

The IETF takes no position regarding the validity or scope of any Intellectual Property Rights or other rights that might be claimed to pertain to the implementation or use of the technology described in this document or the extent to which any license under such rights might or might not be available; nor does it represent that it has made any independent effort to identify any such rights. Information on the procedures with respect to rights in RFC documents can be found in BCP 78 and BCP 79.

Copies of IPR disclosures made to the IETF Secretariat and any assurances of licenses to be made available, or the result of an attempt made to obtain a general license or permission for the use of such proprietary rights by implementers or users of this specification can be obtained from the IETF on-line IPR repository at http://www.ietf.org/ipr.

The IETF invites any interested party to bring to its attention any copyrights, patents or patent applications, or other proprietary rights that may cover technology that may be required to implement this standard. Please address the information to the IETF at [email protected].

Acknowledgement

Funding for the RFC Editor function is currently provided by the Internet Society.